Drive belt tension should also be checked at this time. When parking your vehicle, always leave a manual transmission in first gear and apply the parking brake fully to guard against vehicle movement and possible injury or damage. Even if the display still reads a few degrees above 32°F 0°C , the road surface may be icy, particularly in woods or on bridges. On vehicles equipped with a limited-slip differen- tial, never run the engine with one rear wheel off the ground. Driving with the flip-up window open can allow poisonous exhaust gases into your vehicle. Pull down on the height adjuster to make sure it is locked in place.
Retighten them, if required, and torque to the values specified in the Service Manual. Failure to do so may allow the vehicle to roll and cause damage or injury. This should clear any excess fuel in case the engine is flooded. Under normal operating conditions, the catalytic con- verter will not require maintenance. The seat belt might not be properly adjusted and you could be injured. Drive carefully under such conditions to prevent an accident and possible per- sonal injury or property damage.
The brake pedal must be depressed to shift out of Park P. It is great to have, will save you a lot and know more aboutyour 2005 Jeep Liberty, in the long run. Raise the vehicle by turning the jack screw to the right. The sudden movement of the seat could cause you to lose control. Metal objects placed within the line of sight of the antenna will cause decreased performance. Turn Signal Indicator Light The arrows will flash in unison with the exterior turn signals, when using the multi-function control lever.
The following maintenance recommendations will enable you to obtain maximum benefit from the corrosion resistance built into your vehicle. Position the shoulder belt height adjusters so that the belt rests across the middle of your shoulder. Continue to hold the Lock button, wait at least 4 but no longer than 10 seconds, then press the Panic button. Purchasing your own repair manual can save you money on maintenance and repair. The Selec-Trac transfer case is not equipped with a synchronizer and therefore the front and rear driveshaft speeds must be equal for the shift to take place.
If the transmission gets too hot, the transmission will change the way it shifts to help control the condition. Do not attempt sharp turns or abrupt maneuvers or other unsafe driving actions that can cause loss of vehicle control. After 10 seconds, a single chime will sound. Inspect the engine air filter element, replace if necessary. The inflating window bag pushes the outside edge of the headliner out of the way and covers the window. If this happens, you can push down on the accelerator pedal to maintain the desired speed.
Make sure not to damage the rubber gasket material during removal. They will help you keep your vehicle operating at its best. Store the heavier items down low and be sure that the weight is distributed equally. Therefore, make sure the keys are not inside the vehicle before closing the door. Drive moderately during the first 300 miles 500 km. You can strike the interior of your vehicle or other passengers, or you can be thrown out of the vehicle. Be sure to keep your foot on the brake when moving the shift lever between these gears.
Inspect the drive belt, and replace as needed. If the problem continues, the message will appear the next time the vehicle is started. Fog Light Indicator Light — If Equipped This light shows when the front fog lights are on. The current channel name and number will then be displayed until an action occurs. Most matters can be resolved with this process.
To avoid injury stand back when opening. The park lights will flash twice to acknowledge the unlock signal. Inspect the drive belt, and replace as needed. They are couch-like buckets, softer and much more contoured than the seats in the Ford Escape. Use it when your vehicle is disabled on or near the road. Also, additional factory-installed options, or dealer-installed options, must be considered as part of the total load on your vehicle. The use of lower quality water will reduce the amount of corrosion protection in the engine cooling system.